Fully-Sintered Diamond Burs HP
Lodden
Fully sintered diamond burs with an HP shank. Diamond runs through the whole body of the tool rather than sitting on its surface, so fresh grit is exposed as it wears and the cut stays consistent over the tool’s life. They cost more than electroplated burs and last far longer.
More in this category
Milling Burs — Amann GirrbachLodden milling burs for the Amann Girrbach machine, for cutting zirconia. The geometry matches the tool holders and speeds of Amann Girrbach machines. They are a consumable, replaced according to running hours and to the margin quality the machine produces. JK Dent keeps them in stock.
Milling Burs — Sirona MC X5Lodden milling burs for the Sirona inLab MC X5 machine, for cutting zirconia. The MC X5 runs wet and dry; these burs are for its zirconia route. They are a consumable, replaced according to running hours and to the margin quality the machine produces. JK Dent keeps them in stock.
Milling Burs — ArumLodden milling burs for the Arum machine, for cutting zirconia. They suit the Arum dry-milling series where zirconia is the main material. They are a consumable, replaced according to running hours and to the margin quality the machine produces. JK Dent keeps them in stock.
Milling Burs — imes-icore 350iLodden milling burs for the imes-icore 350i machine, for cutting zirconia. The 350i is a high-throughput laboratory machine; these burs are meant to hold a clean margin across long runs. They are a consumable, replaced according to running hours and to the margin quality the machine produces. JK Dent keeps them in stock.
Contact us
A site visit, measurements and an initial plan with a price range — no obligation.
Leave a detailed message
Even outside business hours — we will get back to you.